The panel install playbook.
Practical panel-siding guidance that links the exact current sources used. The panel manufacturer's instructions and applicable code govern.
The panel siding installation guide
The full crew sequence from wall prep to final reveal, linking every detail below.
Read the guide Reference · Our dataHow much does a 4x8 sheet of panel siding weigh?
Every published figure with its source, the 49 percent spread the published record cannot agree on, and what it means for a two-person lift.
See the weights The straight answerWhy panel siding is a two-person job
What the second person is actually doing, which phase a support tool removes, and what we will not claim.
Read the guide The straight answerCan you install panel siding by yourself?
What goes wrong when a sheet gets away from you, which tools are sold for solo work, and why ours is not one of them.
Read the guide The methodHow the EZpanl support line works
The six steps, the anatomy of the hook, and why the fastener ends up behind the finished panel.
See how it works How-ToHow to hang a 4x8 siding panel
The five things crews use to hold a full sheet while they fasten it, including the free ones, and what each one costs you.
Read the guide How-ToHow to install T1-11 siding
The crew sequence from snapping the line to nailing off, shiplap versus square edge, and what governs the numbers.
Read the guide How-ToHow do you hold a siding panel in place while you fasten it?
Every support option for rigid full panels, compared honestly.
Read the guide How-ToHow do you keep a siding panel from sliding while you fasten it?
The two directions a sheet moves, the bracket trick crews already use, and where each method runs out.
Read the guide How-ToStarting level when the foundation is not
Level off the building, not the ground. Finding the point, snapping the line, and what to do with the gap.
Read the guide How-ToTemporary ledger boards, and what they cost you
The scrap board works. Here is the part nobody writes down about taking it off again.
Read the guide How-ToReplacing improvised ledger boards on panel work
The scrap-cleat routine of fasten, remove, patch, rebuild, versus a repeatable support line.
Read the guide CompareEZpanl vs cleats vs panel clamps
How each attaches, what each costs, and the labor each one takes.
Read the guide CompareLooking for a siding gauge alternative?
Why lap-siding gauges are built for plank, and what actually works on a full sheet.
Compare the tools CompareIs there a drywall lift for siding panels?
They rent from any yard and they are built for ceilings. Where a lift helps on a wall, and where it gets in the way.
Read the guide Kit listWhat tools do you need to install panel siding?
The kit a crew actually carries, what changes on fiber cement, and the one item most lists leave off.
Read the guide SpecHow to read a panel siding nailing schedule
Fastener type, penetration, and edge-versus-field spacing, and where to find yours.
Read the guide SpecPanel siding clearance and gap basics
Clearance to grade, roofs, and decks, plus gapping at joints, and what each protects against.
Read the guideEach guide links the exact current sources it draws on. The two spec guides teach how to read and source the governing numbers rather than restating them, because your panel manufacturer's current printed instructions always govern.
Sixteen hooks. One level line.
Every guide here comes back to the same few minutes of the job: the part where the panel is up, and nobody's hands are free. That is the part the kit takes off you.
See the Siding Hook Kit